Step 6: Backguard Installation; To Clean And Protect Exterior Surfaces - Thermador P24WK Installation Instructions Manual

A Low Back backguard must be in-
stalled when there is less than a 12"
clearance between combustibles and
back edge of cooktop. (See Fig. 1 and
5.) For island installations and other
installations with over 12" clearance, an
optional stainless steel trim channel is
available to cover the backguard mount-
ing flanges. Attach the backguard be-
fore sliding the appliance into the final
installed position. Follow Steps A
through C below:
A. Slide backguard over the two flanges
on the rear of the appliance. Fasten
the front and back with two screws
(see A, Fig. 12) provided. No screws
are required behind the griddle sec-
tion.
B. Fasten the top of the backguard to
the wall with two screws through
the backguard. (See B, Fig. 12.)
C. Place the backguard cap on top and
fasten using the two counter-sink
screws provided. (See C, Fig. 12.)
LOW BACK AND ISLAND TRIM MODEL NUMBERS
COOKTOP MODEL NO. 12" LOW BACK
P24WK
PC36
PC48
*Requires a minimum of 12" horizontal clearance between back of appliance and combustible materials.

TO CLEAN AND PROTECT EXTERIOR SURFACES

The stainless steel surfaces may be cleaned by
wiping with a damp soapy cloth. Any mild glass
cleaner will remove fingerprints and smears.
Follow all cleaning by rinsing with clear water.
Wipe dry with a clean soft cloth to avoid water
marks. For discolorations or deposits that persist,
use a non-scratching household cleanser or stain-
less steel polishing powder with a little water and
a soft cloth. For stubborn cases, use a plastic
scouring pad or soft bristle brush together with
cleanser and water. Rub lightly in direction of
polishing lines or "grain" of the stainless finish.
Avoid using too much pressure which may mar the
surface.

Step 6: Backguard Installation

Fig. 12 Low Back Attachment
GP24LBS
GPS36LBS
GPS48LBS
C
B
A
Island Trim*
GP24ITS
GPS36ITS
GPS48ITS
Use a stainless steel cleaner/polish to protect the
finish and maintain appearance.
DO NOT allow deposits to remain for long periods
of time.
DO NOT use ordinary steel wool or steel brushes.
Small bits of steel may adhere to the surface
causing rust.
DO NOT allow salt solutions, disinfectants,
bleaches or cleaning compounds to remain in
contact with stainless steel for extended periods.
Many of these compounds contain chemicals which
could prove harmful. Rinse with water after expo-
sure and wipe dry with a clean cloth.
12