Thermador P24GE Installation Instructions Manual
Thermador P24GE Installation Instructions Manual

Thermador P24GE Installation Instructions Manual

Professional cooktops
Hide thumbs Also See for P24GE:

Advertisement

Available languages

Available languages

For Thermador ProfessionaP
Cooktops
'l
Des tables de cuisson Thermador
Professional ®
IAnAmer_co,_Ico_°
ModeLs
P24GE
P24WK
PC30
PC36
PC48

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P24GE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Thermador P24GE

  • Page 1 ModeLs P24GE For Thermador ProfessionaP Cooktops P24WK PC30 PC36 PC48 Des tables de cuisson Thermador Professional ® IAnAmer_co,_Ico_°...
  • Page 2 Contents Warnings ..................Below Introduction ..................Important Installation Information ............Step 1: Ventilation Requirements ............Step 2: Cabinet Preparation ............4 - 7 Step 3: Unpacking, Moving, Placing and Anchoring the Cooktop ..8 Step 4: Gas Requirements and Hookup ........
  • Page 3 12" horizontal clearance between combustible materials and the back edge of the cooktop. Thermador Back backguard must be ordered separately installed at the rear of the cooktop. For island installations and other installations with more than 12"...
  • Page 4: Installation Information

    Important Installation information This appliance has been CAUTION CAUTION certified for safe operation up to an elevation of 10,200 ft. without To eliminate risk of burns (1) Whenconnectingtheunitto any modifications. Exception: fire caused by reaching over propane gas, make certain use with Propane, the appliance heated surface...
  • Page 5 3. Consider Make-Up Air: indicates the Thermador hoods, width appliance Due to the high volume model number, that cooking surface. Where ventilation air, a source recommended...
  • Page 6 A and the back edge cord to pass through. of the cooktop above the cooking su dace, a Thermador Always keep appliance area clean and free from combustible materials, gasoline and other flammable Low Back backguard must be installed.
  • Page 7 Step 2: Cabinet Preparation FIG. 1 30" to38" WideHoodfor 24"Wokor 24"Griddle FIG. 2 30" to38" WideHoodfor 30" Cooktop Clearance Installing _' to42" WideHoodfo_ Combustible Requirements 48" to80" WideHoodfor 48" Cooktop t Material A Side Supports (both sides) VENT HOOD Counter 36"...
  • Page 8: Step 2: Cabinet Preparation

    With more than 12" of clearance, the Island Trim may be used. HG. 8 mnstaLlation of 48" Cooktop above side=by=side Thermador Warming Drawers, Model No. WD24 Minimum 3/4" Side View 7-W16" Plywood support "_(19,8 cm) 3/4"...
  • Page 9 Step 2: Cabinet Preparation F_G, 9 Front = Bottom of Unit, See Detail B, Below A manual valve must be 3-Prong grounding type installed external to the receptacle connected to appliance, in an accessible a properly grounded and location from the front, for polarized electrical supply the purpose of shutting off rated at 120VAC, I0 Amps,...
  • Page 10 Step 3: Unpacking, Moving, Placing and Anchoring the Cooktop IMPORTANT CAUTION Proper equipment and adequate manpower • Verify that the appliance is correct the type of gas being provided. Refer must be used in moving the appliance to avoid to Step 4 before proceeding with...
  • Page 11: Step 4: Gas Requirements

    Thermador. The field conversion kit for valve before connecting the appliance. all Professional cooktops (PC series) is Thermador The installer should inform the consumer of the Model PLPKIT. Obey all instructions in PLPKIT for correct conversion of the gas regulator and settings location of the gas shut-off valve.
  • Page 12 Step 4: Gas Requirements and Hookup CAUTION: CAUTION When connecting unit to propane gas, make The appliance must be isolated from the gas certain the propane gas tank is equipped with supply piping system by closing its individual its own high pressure regulator in addition...
  • Page 13 Step S: Electrical Requirements, Connection and Grounding Observe allgoverningcodes For aii 240 VAC models, connect CAUTnON: mmproper ordinances when grounding. Mack (L!) to black, red (L2) to grounding reverse the absence of these codes or red, white wire to neutral _o_arization will cause...
  • Page 14: Installation

    Step 6: Backguard Installation ALow Back backguard must be installed FIG. 12 Low Back Attachment when there is less than a 12" clearance between combustibles and back edge of cooktop. (See Fig. 1 and 5.) For island installations and other installations with C _/ over 12"...
  • Page 15: Step 7: Burner Test And Adjustment

    If any burners do not carry over, call Thermador®. Air shutters of tube-style burners are pre-adjust- The two far left burners feature XLO®, causing the...
  • Page 16 Step 7: Burner Test and Adjustment FiG. 14 Flame Adjustment (if necessary): Tube=style burners used in Thermador© Air Shutter Adjustment (if necessary) appliances have air shutter systems which similar to the illustration in Figure 14, and can be Screw adjusted...
  • Page 17 FmNAL CHECK GAS SUPPLY OPERATION Connection: 1/2" NPTwith Cooktop correctly positioned All internal packing materials minimum 3/4" diameter flex in countertop recess. removed. (Check below line. grates and grill pans.) Specified clearances maintained cabinet Bezels centered on burner If converting from natural surfaces.
  • Page 18 Table des mati res Avertissements ..............16 (ci-dessous) Introduction ....................Information importante & propos de I'installation ........Chapitre 1 : Exigences de ventilation ............Chapitre 2 : Pr6paration de Femplacement ........20 - 23 Chapitre 3 : D6ballage, manutention, mise en place et fixation de la table de cuisson ................
  • Page 19 30,5 cm (12"). La plaque de protection basse Thermador est a commander separ6ment et doit @tre installee a I'arriere de la table de cuisson.
  • Page 20 Information importante a propos de l'installation Cet appareil est certifie ACNOR MtSE EN GARDE & des fins de fonctionnement M!SE EN GARDE secudtaire jusqu'& el6va- Afin d'_[iminer (1) Si I'appareil est alimente tion de 10 200 pi sans modifica- au gaz propane, assurez- risques br_lures...
  • Page 21 ; d'oQ l'importance de capter l'echappement de cuisson. **Thermador offre un choix de souffleries a distance (VTRI030D ou VTR1530D) ou interne (VTNI030C) pour utiJisation avec les installations murales.
  • Page 22 12. Pour Finsta!lationde la table de cuisson de 1,22 m (48") positions, avec la partie frontale au m6me niveau que le sur les deuxtiroirs chauffe°platsc6te a cSte de Thermador plan de travail ou en projection avant, selon la profondeur (modele WD24), reportezovous a la Figure 8. Si vous...
  • Page 23 Chapitre 2 : Preparation de l'emplacement 30 poa 36 pohottelargepourwokou grillede 24po FIG. 1 30 poa 36 pohottelargepourtable decuissonde30 po FIG. 2 Installation D6gagements ,36 poa 42 po hottelar_ cuissonde36 po de supports hottelargepourtable decuissonde48 po COMBUSTIBLES lat_raux (des deux c6t_s) 76,2cm =30"...
  • Page 24 Chapitre 2 : Pr6paration de l'emplacement FIG. 7 -Au ras du FIG. 5 =Vue lat6rale de la table FIG. 6 = Projection devant I'armoire de cuisson panneau frontal l'armoire Laissez deI'espace p our lesvis 12,7 30,5 enaugmentant lahauteur dela mrs1 c m d_ooupe de1,6mm(I/16')ou !"} (12") enfaisant desencoches pour...
  • Page 25 Chapitre 2 : Pr6paration de l'emplacement FiG, 9 Pattie frontale inf_rieute de I'appareil, voit vue _clat_e B ci=dessous Plaquede caracteristiques d u produit/Etiquette d e scrie Les enduits de joints doivent &tre resistants aa gaz propane. R24WOK 1/2"NPT Un robinet d'arr_t doit Prise murale...
  • Page 26: De La Plaque De Cuisson

    Chapitre 3 : D6ballage, manutention et raise en place et fixation de la table de cuisson MiSE EN GARDE Assurez-vous que I'appareil correspond au type de gaz utilis_ equipement adapte manipule le lieu d'installation. Reportez_vous personnel experiment6 dolt _tre utilise au Chapitre 4 avant de poursuivre...
  • Page 27 Chapitre 4 : E×igences pour M'aMimentation du gaz et raccordement RACCORDEMENT Los tables de ouisson sent pr_par_es _ J'usine avant expedition pour _tre aliment_es par du gaz Un robinet manuel d"arr6t de gaz doit _tre installe nature{. Doivent _tre oenvertis pour utiJisatien I'exterieur de i'appareil, a un endreit accessible par ie...
  • Page 28 Chapitre 4 : E×igences pour FaHmentation du gaz et raccordement MISE EN GARDE MtSE EN GARDE Si I'appareil est alimente par du gaz propane, Uappareil doit 6tre isole du systeme d"arrivee de assurez-vous que le reservoir de propane est gaz en fermant le robinet manuel d'arr_t pendant equip6 de son propre detendeur en sus du...
  • Page 29 Chapitre 5 : Exigences pour l'aiimentation @lectrique, le branchement et la raise a la terre sera appliqu& Reportez=vous MISE EN GARDE HG. 10. M@thode la figure 10 pour la methode recommand@e de raise _ la Une raise _ [a terre inadequate conseillee de mise a la terre.
  • Page 30 Chapitre 6 : Installation de la plaque de protection II est obligatoire d'installer une plaque FIG. 12. Posede la plaquede protectionbasse de protection basse si la distance entre les materiaux combustibles et le bord arriere de la table de cuisson inferieur &...
  • Page 31 Si Les obturateurs d'air des br0teurs tubes sont les brQleurs ne sont pas enveloppes, communi= quer avec Thermador®. preregles en usine et ne requierent habituel- lement pas d'autre reglage sauf dans les cas...
  • Page 32 & suivre jusqu'& ce que les caracteristiques de la flamme soient ceptables (voir figure 13). AVERTISSEMENT Communiquer avec Thermador@ si : 1. Un brQleur ne s'allurne pas. Les reglages de br_leurs doivent 6tre effec= 2. Si un brQleur continue de brQler jaune.
  • Page 33: Pour L'installateur

    Liste de v6rification pour l'installateur ALIMENTATION EN GAZ USTE HNALE FONCTIONNEMENT CJ Tous materiaux Raccord " un filetage CJ La table de cuisson bien 12,7mm (1/2") avec d'emballage ont et6 enleves tuyau flexible d'un diametre & I'intedeur. (Vedfiez sous les positionnee minimum de 19,1 mm (3/4")
  • Page 34 V euilJez vousrenseigner aupres devotredistributeur oudetailJant local. jA Ame,, co, Icon° 5551 McFadden Avenue, Huntington Beach, CA 92649 • 800=735=4328 o www.thermador.com 9000236112 • ECO# 5U01BJo 02/07 • @ BSH Home Appliances Corporation, 2007 • All rights reserved Litho in U.S.A.

This manual is also suitable for:

P24wkPc30Pc36Pc48

Table of Contents