Cleaning And Lubricating The; Miter Saw - Chicago Electric 98194 Set Up And Operating Instructions Manual

side of the Blade slightly clears the edge
of the Kerf Board. Loosen the Bevel
Lock and set the Bevel Angle at 45º left.
Ensure that the left side of the Blade
clears the Kerf Board. Tighten the four
screws holding the Kerf Board in place.
Cleaning and lubricating the miter
1. Observe the Dust Bag while using
the saw. Empty the sawdust into an
appropriate container when the bag is
full.
2. Occasionally wipe or blow off sawdust
that accumulates on the saw. Saw dust
on the Fence can cause you to make
inaccurate cuts.
3. Keep the Slides free of sawdust. Wipe
or blow them off as required. Use a dry
lubricant or wax on the slides. Do not
use an oil or grease lubricant, as this will
attract dust.
4. Occasionally lubricate the pivot point of
the Table as well as other moving parts
with a dry lubricant, such as graphite.
reV 09j
SKU 98194
Saw
For technical questions, please call 1-800-444-3353. Page 18