Table of Contents
Advertisement
8.
uSe right tool.
attachment to do a job for which it was
not designed.
reCommended minimum wire
gauge For extenSion CordS
(120 Volt)
nameplate
ampereS
(at full load)
0 – 6
6.1 – 10
10.1 – 12
12.1 – 16
table a
9.
uSe proper extenSion Cord.
Make sure your extension cord is in good
condition. When using an extension
cord, be sure to use one heavy enough
to carry the current your product will
draw. An undersized cord will cause a
drop in line voltage resulting in loss of
power and overheating. Table A shows
the correct size to use depending on
cord length and nameplate ampere
rating. If in doubt, use the next heavier
gage. The smaller the gage number, the
heavier the cord.
10.
wear proper apparel.
wear loose clothing, gloves, neckties,
rings, bracelets, or other jewelry which
may get caught in moving parts. Nonslip
footwear is recommended. Wear
protective hair covering to contain long
hair.
alwaYS uSe SaFetY glaSSeS.
11.
use face or dust mask if cutting operation
is dusty. Everyday eyeglasses only have
impact resistant lenses, they are NOT
safety glasses.
12.
SeCure work.
to hold work when practical. It's safer
SKU 98194
Don't force tool or
extenSion Cord
length
25'
50'
100'
18
16
16
18
16
14
16
16
14
14
12
do not use.
Do not
Use clamps or a vise
For technical questions, please call 1-800-444-3353.
than using your hand and it frees both
hands to operate tool.
13.
don't oVerreaCh.
footing and balance at all times.
14.
maintain toolS with Care.
tools sharp and clean for best and safest
performance. Follow instructions for
lubricating and changing accessories.
150'
15.
diSConneCt toolS
14
when changing accessories, such as
12
blades, bits, cutters, and the like.
12
16.
reduCe the riSk oF
unintentional Starting. Make
sure switch is in off position before
plugging in.
17.
uSe reCommended aCCeSSorieS.
Consult the owner's manual for
recommended accessories. The use of
improper accessories may cause risk of
injury to persons.
18.
neVer Stand on tool.
injury could occur if the tool is tipped
or if the cutting tool is unintentionally
contacted.
19.
CheCk damaged partS.
further use of the tool, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended
function – check for alignment of moving
parts, binding of moving parts, breakage
of parts, mounting, and any other
conditions that may affect its operation.
A guard or other part that is damaged
Also
should be properly repaired or replaced.
20.
direCtion oF Feed.
a blade or cutter against the direction of
rotation of the blade or cutter only.
21.
neVer leaVe tool running
unattended. turn power oFF.
Keep proper
Keep
before servicing;
Serious
Before
Feed work into
Page 4
Hide quick links:
Advertisement
Table of Contents
