Operating Instructions; Work Piece And Work Area Set Up; Instructions - Chicago Electric 98194 Set Up And Operating Instructions Manual

commercially available support or home
made saw table. There are bolt holes
provided in each of the four legs of the
base. These should be firmly mounted
using bolts (not included) to your saw
stand or saw table (not included). This
will help prevent tipping or movement
of the saw, preventing injury. Also, the
use of a saw table will make it easier
to efficiently handle work materials and
make more accurate cuts.
Calibration after Shipping
1. During shipment, the Fence and
Bevel Angle may come slightly out of
alignment.
2. Both need to be adjusted for safe
accurate operation. Follow the
instructions under
Fence adjusting the bevel
&
angle
on pages 16 & 17.

operating inStruCtionS

read the entire important
SaFetY inFormation section at
the beginning of this manual
including all text under
subheadings therein before set up
or use of this product.
warning
From aCCidental
operation:
unplug power cord from power
source before making any
adjustments to this tool.

work piece and work area Set up

1. Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent
injury and distraction.
reV 09j
SKU 98194
adjusting the
to preVent
SeriouS injurY
For technical questions, please call 1-800-444-3353.
2. Route the power cord along a safe
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage. The
power cord must reach the work area
with enough extra length to allow free
movement while working.
3. Use a saw table, saw stand or other
means to support the work piece. The
Miter Saw must be mounted in such
a way that the surface is level to the
ground, and supports used must provide
a surface on the same level as the saw
table. If the work surface and any work
materials supports are not level, and on
the same level, unwanted bevel angles
will appear in the cuts resulting in poor
joinery.
4. Work pieces may be secured to the saw
table using the Hold Down Clamp or
other clamping devices (not included).
Securing the work piece will provide
safety by preventing kick back and by
removing the need to hold work pieces
near the blade by hand. Clamping the
work piece will also improve cutting
accuracy by preventing the work piece
from moving during the cutting operation.
5. When using this saw, work pieces are
often quite long. Allow room on both
left and right of saw for extended work
pieces.
general operating instructions
1. This saw is equipped with a laser guide.
When the switch on the side of the
laser battery housing is turned on, the
beam shows the location of the cut. Do
not move or bend the laser opening
because the accuracy of the guide will
be effected.
2. When the Handle is lowered, the Blade
Guard raises automatically. When
Page 10