Chicago Electric 98194 Set Up And Operating Instructions Manual page 13

3. Blow any sawdust or debris away from
the Fence. Place the work material
against the Fence.
4. Make any necessary miter or bevel
adjustments.
5. Turn the Laser guide on, using the switch
on the side of the laser battery housing.
6. Align the marked location of the cut on
the work material with the saw blade. Be
aware that the Saw Blade will remove
material from the cut equal to the width
of the blade. This is the "kerf". To prevent
your work piece from being cut too short,
align the edge of the blade with your
measured mark, keeping the kerf on the
waste side of the cut.
7. Hold the work material in place using
the Hold Down Vise. Ensure that the
work material is level and supported
securely, using saw horses or supports if
necessary.
8. Grip the Saw Handle, press the Trigger
Lock Button and squeeze the Trigger to
start the Blade turning.
9. Pressing down lightly, move the Blade
smoothly across the work material to cut
it. With narrow material, you can press
straight down "chopping" the material.
With wider material you must move the
Blade across the material to cut it. Do
not bear down on the material, use light
downward pressure. If the material binds
the blade, release the trigger. Keep your
hands away from the Blade.
10. When the cut is completed, raise the
blade assembly, wait for the Blade to
stop turning, release the Hold Down Vise
and remove the work material from the
saw.
11. the laser guide will not turn off
automatically. turn the laser guide
SKU 98194 For technical questions, please call 1-800-444-3353.
off using the switch on the side of the
laser battery housing. This is important
to prevent accidental eye exposure to
the laser beam.
Page 13