Maintenance And Servicing; Cleaning, Maintenance, And Lubrication - Chicago Electric 98194 Set Up And Operating Instructions Manual

maintenanCe and
SerViCing
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
to preVent
warning
SeriouS injurY
From aCCidental
operation:
turn the power Switch of the tool
to its "oFF" position and unplug
the tool from its electrical outlet
before performing any
inspection, maintenance, or
cleaning procedures.
to preVent SeriouS injurY
From tool Failure: do not
use damaged equipment. if
abnormal noise or vibration
occurs, have the problem
corrected before further use.
SKU 98194 For technical questions, please call 1-800-444-3353.
Cleaning and maintenance
1. beFore eaCh uSe,
general condition of the tool. Check for
loose screws, misalignment or binding of
moving parts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its safe
operation.
2. aFter uSe,
of the tool with clean, moist cloth. To
prevent accidents, turn off the tool and
disconnect its power supply after use.
Clean, then store the tool indoors out of
children's reach.
3. If the blade has become dirty, use a
blade cleaner (not included) to clean it.
Dirty blades will bind more easily, and
will more often overheat and burn the
wood as it cuts. Overheated blades dull
more easily.
4. If the Blade has become dull, replace it.
Dull blades will cause increased tear-out
and ragged edges on the cuts.
5. Occasionally clean the Slides, rotating
Table components and other moving
parts. Use a good quality dry lubricant
(not included) which will not attract dust.
6. To replace the laser Batteries: Slide the
cover off the laser housing as shown
in the diagram above. Replace the
batteries with two 'AAA' batteries and
close the cover. Caution! to prevent
injury, position batteries in proper
polarity and do not install batteries
of different types, charge levels, or
capacities together.
7. warning! if the supply cord of
this power tool is damaged, it must be
replaced only by a qualified service
technician.
inspect the
clean external surfaces
Page 14