Table of Contents
Advertisement
5.
Once the bevel angle is adjusted,
adjust the Bevel Angle Indicator to
read 0º when the Saw Blade is in the
vertical position. Loosen the screw
holding the Indicator in place, adjust
it to be exactly over the 0º mark, then
retighten the screw.
adjusting or replacing the kerf
board
1.
If the Kerf Board becomes damaged
it must be replaced.
2.
Remove the two Bolts (82) holding
the Fence (83) in place and remove
the Fence.
3.
Remove the three screws holding the
Kerf Board in place.
4.
Install a new Kerf Board. Replace
the three screws and tighten them
slightly.
5.
To adjust the Kerf Board, lower the
Saw Blade and lock it down with the
Locking Pin. Adjust the Kerf Board
so the right side of the Blade slightly
clears the edge of the Kerf Board.
Loosen the Bevel Knob (71) and set
the Bevel Angle at 45º left. Ensure
that the left side of the Blade clears
the Kerf Board. Tighten the four
screws holding the Kerf Board in
place.
6.
Replace the Fence.
Cleaning and lubricating the
miter Saw
1.
Observe the Dust Bag while using
the saw. Empty the sawdust into an
appropriate container when the bag
is full.
SKU 67411
For technical questions, please call 1-800-444-3353.
2.
Occasionally wipe or blow off
sawdust that accumulates on the
saw. Saw dust on the Fence can
cause you to make inaccurate cuts.
3.
Occasionally lubricate the pivot point
of the Table as well as other moving
parts with a dry lubricant.
Page 17
Advertisement
Table of Contents
