Operating Instructions
Read the ENTIRE IMPORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set up
TO PREVENT SERIOuS INJuRy FROM AccIDENTAL OPERATION:
Squeeze and release the Trigger and unplug the tool from its electrical
outlet before performing any procedure in this section.
Installing the Saw Blade
1. If there is an installed blade, remove it by
twisting open the Chuck and pulling the blade
out. To open the Chuck, twist it counterclockwise
and hold it in the open position.
2. Release the Chuck to close it.
3. To install the new Saw Blade, twist and hold the
Chuck counterclockwise while inserting the Saw
Blade and pushing it in to its deepest position.
Handle Rotation
1. For comfort and controlled cutting from any
angle, the Handle may be rotated up to
180° with five positive stops (0°, 45°, 90°
to the left and 45° and 90° to the right).
Item 62370
For technical questions, please call 1-888-866-5797.
4. Release the Chuck to close it.
5. Check that the Saw Blade is firmly locked in
place and that the teeth are pointed downward.
WARNING! To prevent serious injury: Before
plugging in the Power Cord for each use, wearing
work gloves, pull on the Saw Blade to make
sure it is securely locked in the Chuck.
2. To rotate the Handle, press the Rotation Switch,
turn the Handle to the desired position, and
release the Handle Rotation Switch. Make sure
the Handle is locked into the chosen position.
Page 9