G Copying From The Document Glass; Copying From The Document Glass - Sharp AR-C170M Operation Manual

Copying from the document glass

When copying originals which cannot be fed from the reversing single pass feeder such as thick originals, open the
document cover and copy the originals from the document glass.
NOTE
Certain restrictions exist depending on the amount of memory installed and the copy settings. (See "Copy mode
output restrictions" and "Specifications for memory capacity and maximum number of originals" on page 5-4.)
I I I I 1-sided copies of 1-sided originals
Original
1 Set an original on the document glass.
(page 4-6)
Original size detector
[ How to place the original ]
Place the original in the appropriate position shown
below according to its size. (
the centring scale.)
Original scale
Centring scale
A4 or 8½x11
A3 or 11x17
B4 or
8½x14
A5 or
5½x8½
Ensure that the 1-sided to 1-sided copy
2
mode is selected.
ORIGINAL
A4
PLAIN
B5
A4
DUPLEX
A4
A3
Copy
NOTE
Do not place any objects
under the original size
detector, because they
may damage it or the
original size may not be
detected properly.
Centre the original on
Original scale
Centring scale
A4 or
R
8½x11
R
The one-sided to one-
sided mode is selected
when no icon for a two-
sided mode appears in
the dashed area on the
display.
3 Ensure that paper of the same size as the
original is automatically selected. (*Note)
AUTO A4
PAPER SELECT
100 %
message above is displayed, copying can be
performed onto the currently selected paper.
(*Note) The following requirements must be
satisfied.
Originals of a standard size (A3, B4, A4, A4R, B5,
B5R or A5 (11" x 17", 8-1/2" x 14", 8-1/2" x 11", 8-
1/2" x 11"R or 5-1/2" x 8-1/2")) are set and the auto
paper select function is enabled.
PLAIN
A4
B4 RECYCLED
A3
PLAIN
The selected key will be highlighted and the paper
selection screen will close. To close the paper
selection screen without making a selection, touch
the [PAPER SELECT] key.
NORMAL COPYING
The selected tray will be
highlighted or the
message "LOAD xxxxxx
PAPER." will appear. If
the message appears,
load paper in a paper
tray with paper of the
required size. Even if the
If originals of a size other
than the sizes above are
to be copied, manually
select the desired paper
size by touching the
[PAPER SELECT] key
and then touching the
desired paper size
selection key.
5-7
5