Reversing Single Pass Feeder; G Acceptable Originals; Acceptable Originals - Sharp AR-C170M Operation Manual

REVERSING SINGLE PASS FEEDER

The reversing single pass feeder can be used to automatically feed originals for continuous copying. Both sides of
two-sided sheet originals can be scanned without having to manually turn the originals over. This feature is
convenient for making copies of a large number of originals.

Acceptable originals

When the reversing single pass feeder is used, up to 40 originals of the same size can be set in the feeder (maximum
stack thickness of 4 mm, or 30 originals of weight 90 g/m
I I I I Size and weight of acceptable originals
A5 or
5-1/2" x 8-1/2"
Original size:
(148 x 210 mm)
Weight (thickness):
56g/m or 2
2
g/m ... Weight of a sheet of paper of 1 m
Notes on use of the reversing single pass feeder
GUse originals within the specified size and weight ranges. Use of originals out of the specified range may cause
an original misfeed.
GBefore loading originals into the document feeder tray, be sure to remove any staples or paper clips.
GIf originals have damp spots from correction fluid, ink or glue from pasteups, be sure they are dried before they
are fed. If not, the interior of the document feeder or the document glass may be soiled.
GTo prevent incorrect original size detection, original misfeeds or smudges on copies, use the following as a
guide for feeding originals.
Transparency film, tracing paper, carbon paper, thermal paper or originals printed with thermal transfer ink
ribbon should not be fed through the document feeder. Originals to be fed through the feeder should not be
damaged, crumpled or folded or have loosely pasted paper on them or cutouts in them.
A3 or
11" x 17"
(297 x 420 mm)
15 lbs. 90g/m or 2 24 lbs.
2
).
2
4
4-5