Sharp AR-C170M Operation Manual page 131

Problem
Order of copies Is the order of originals correct?
incorrect
Colour copies are being made on special
paper such as heavy paper 2, transparency
film, or envelopes (paper that can only be
output face up).
Job cancellation Is a message requesting cancellation of job
needed displayed?
Scanning of Is a message indicating memory is full
originals is displayed?
incomplete.
The selected Has "Sort" been selected and is colour
number of sets of copying being performed?
copies is not printed.
Not all pages are When making black and white copies, the
copied memory became full during scanning of the
originals and a message appears asking
you whether you want to continue copying or
cancel.
Check
TROUBLESHOOTING
Solution or cause
When using the document glass, set the
originals from the first page one sheet at a
time.
When using the reversing single pass
feeder, set the originals with the first page
up.
When special paper such as heavy paper 2,
transparency film, or envelopes (paper that
cannot be output to the centre tray) is used,
copies are output face up to the left tray.
When making colour copies on paper that
can only be output face up, the copies are
output face up in the order of scanning, and
thus the stack of copies is in the reverse
order of the stack of originals. When making
black and white copies on paper that can
only be output face up, the copies are output
face up in the reverse order of scanning, and
thus the stack of copies is in the same order
as the stack of originals.
Press the [CA] (clear all) key to cancel the
current job.
If the data amount exceeds the limit when
using the pamphlet copy or multi shot copy
which requires scanning of all originals,
scanning will be cancelled and copying will
not be performed.
If you install an additional memory, the
storage capacity will increase.
When colour copying is performed and
"Sort" is selected, only one set of copies can
be made. If more than one set is needed,
replace the original and repeat the copy
procedure for each set needed.
When the memory becomes full during
scanning of the originals, you can select
whether you want to continue the job and
print only those originals that were scanned,
or cancel the job. If you continue the job,
copies will only be made of the originals that
were scanned, and thus all originals cannot
be copied at once.
7
7-5