Sharp AR-C170M Operation Manual page 83

7 Select the desired output mode (see page
5-5).
2-SIDED COPY
OUTPUT
8 Use the numeric keys to set the desired
number of copies.
NOTE
If colour copies are made with the output set to
"Sort", only one set of copies will be made even if a
selection is made for a greater number of copies.
(See page 5-5 "Copy output (sort and group)").
When "Group" is selected, the selected number of
copies will be made (See next page 5-4 "Copy mode
output restrictions").
Press the [COLOUR COPY START (
9
or [BLACK COPY START (
NOTE
The 1-sided to 1-sided copying mode is set as the
default in the initial settings. If the default setting has
not been changed using the "Initial status settings"
program (key operator program), steps 3 to 5 on
page 5-2 can be omitted.
The sort mode is the
default mode.
To select the group
mode, touch the
[OUTPUT] key, then
touch the [GROUP] key
on the output setting
screen, and then touch
the [OK] key on the
setting screen.
Up to 999 can be set.
If you are only making a
single copy, the copy
can be made with the
copy number display
showing "0". Use the [C]
(clear) key to cancel an
entry if a mistake has
been made.
)]
)] key.
If the [C] key is pressed
while originals are being
scanned, scanning will
stop. If copying had
already started, copying
and scanning will stop
after the original in
progress is output to the
original exit area. In
these cases the copy
quantity will be reset to
"0".
NORMAL COPYING
5
5-3