MATSONIC MS7057CT Manual page 56

UR2 Duplex Mode (Half)
This field is available when UART 2 Mode is set to either
ASKIR or IrDA. This item enables you to determine the infra-
red (IR) function of the onboard infrared chip. The options are
Full and Half (default).
Full-duplex means that you can transmit and send information
simultaneously. Half-duplex is the transmission of data in both
directions, but only one direction at a time.
Onboard Parallel Port (378/IRQ7)
This option is used to assign the I/O address and interrupt re-
quest (IRQ) for the onboard parallel port.
Parallel Port Mode (ECP)
Enables you to set the data transfer protocol for your parallel
port. There are four options: SPP (Standard Parallel Port),
EPP (Enhanced Parallel Port), ECP (Extended Capabilities
Port) and ECP+EPP.
SPP allows data output only. Extended Capabilities Port (ECP)
and Enhanced Parallel Port (EPP) are bi-directional modes, al-
lowing both data input and output. ECP and EPP modes are only
supported with EPP and ECP aware peripherals.
ECP Mode Use DMA (3)
When the onboard parallel port is set to ECP mode, the par-
allel port can use DMA 3 or DMA 1.
PWRON After PWR-Fail (Off)
This item enables your computer to automatically restart or
return to its last operating status after power returns from a
power failure.
Game Port Address (201)
This item sets the I/O address for the game port.
Midi Port Address (330)
This item sets the I/O address for the Midi function.
Midi Port IRQ (10)
This item sets the interrupt request for the Midi function.
Press <Esc> to return to the previous screen.
51