MATSONIC MS7057CT Manual page 32

5. Use the audio cable provided with the CD-ROM/DVD
drive to connect to the mainboard CD-in connector
CD1 or CD2 (D).
When you first start up your system, the BIOS should auto-
matically detect your CD-ROM/DVD drive. If it doesn't, enter
the Setup Utility and configure the CD-ROM/DVD drive that
you have installed. See Chapter 3 for more information.
Installing a Floppy Diskette Drive (FDD)
The mainboard has one floppy diskette drive interface (FDD1).
A diskette drive ribbon cable is shipped with the motherboard.
You can install a 5.25-inch drive or a 3.5-inch drive with vari-
ous capacities. The floppy diskette drive cables have one type
of connector for a 5.25-inch drive and another type of con-
nector for a 3.5-inch drive
1. Install the FDD into the drive cage in your ATX system
case.
2. Plug the FDD cable into FDD1 (A):
Note: Ribbon cable connectors are usually keyed so that
they can only be installed correctly on the device
connector. If the connector is not keyed, make sure
FD D
C
B
A
27