Unpacking; Using For The First Time - Martin MAC 700 PROFILE User Manual

• Allow the fixture to cool for at least 45 minutes before opening the fixture or removing the lamp. Protect
hands and eyes with gloves and safety glasses when handling lamps.
• Do not stare directly into the light. Never look at an exposed lamp while it is lit.
• Replace the lamp if it becomes visually deformed, damaged or in any way defective
• Replace the lamp before usage exceeds the maximum service life.
P R O T E C T I O N F R O M B U R N S A N D F I R E
Danger! Intense heat. Avoid contact by persons and materials.
The exterior of the fixture can get very hot – up to 160° C (320° F). Allow the fixture to cool
for at least 45 minutes before handling.
Prolonged exposure to an unshielded lamp can cause eye and skin burns.
• Never attempt to bypass the thermostatic switch or fuses. Always replace defective fuses with ones of the
specified type and rating.
• Keep all combustible materials (for example fabric, wood, paper) at least 0.5 meters (20 inches) away
from the fixture. Keep flammable materials well away from the fixture.
• Do not illuminate surfaces within 1.2 meters (42 inches) of the fixture.
• Provide a minimum clearance of 0.1 meters (4 inches) around fans and air vents.
• Never place filters or other materials over the lens.
• The exterior of the fixture can get very hot. Allow the fixture to cool for at least 45 minutes before handling.
• Do not modify the fixture or install other than genuine Martin parts.
• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).
P R O T E C T I O N F R O M I N J U R Y D U E T O F A L L S
• Do not lift or carry the fixture alone.
• When suspending the fixture, verify that the structure can hold at least 10 times the weight of all installed
devices.
• Check that all external covers and rigging hardware are securely fastened and use an approved means of
secondary attachment such as a safety cable.
• Block access below the work area and work from a stable platform whenever installing, servicing or
removing the fixture.

Unpacking

The MAC 700 Profile is packaged in either a cardboard box or a two-unit flight case that is designed to
protect the product during shipment. The following items are included:
• OSRAM HTI 700/D4/75 lamp (installed)
• 2 clamp attachment brackets
• 5 extra metal gobos and one extra rotating gobo retaining spring
• this user manual
• one 6.3 AT fuse (installed) for use with 200 - 250 V AC power
• one 15 AT fuse for use with 100 -130 V AC power

Using for the first time

Before applying power to the fixture,
• carefully review the safety information on page 5,
• check that the fuse in the fuseholder between the main on/off switch and the power cable matches the
local AC power voltage as described in "Power supply and main fuse" on page 7.
• install a cord cap (mains plug) on the power cable as described in "Power connection" on page 7
• unlock the tilt lock as described on page 24.
When powered up, check lamp alignment as described on page 9.
6 MAC 700 Profile