• The shortcuts (
path between two positions, crossing the open position if necessary, or always avoid the open position.
D I M M E R
The dimmer curve setting (
simulate tungsten dimming or
D I S P L A Y
The display intensity (
display or manually set the intensity to a level from
The display on/off setting (
for 2 minutes after the last key press (
To flip the display, press [Up] and [Down] simultaneously.
L A M P
There are two settings that modify lamp control: Automatic Lamp On (
→
(
When
lamp strikes automatically after the fixture is powered on. When
automatically when the fixture receives DMX data, and it douses 15 minutes after DMX data is lost.
When
from striking at once. The delay is determined by the fixture address.
The DMX Lamp Off (
switches off the lamp. The special combination of DMX values listed on page 29 allows you to execute the
lamp-off command even when disabled.
D M X R E S E T
The DMX reset (
command is fully enabled. When set to
set to
page 29 allows you to execute a reset even when the command is disabled.
C M Y A N D I R I S B L A C K O U T
The CMY blackout (
effectiveness. When set to
absorb any light that may escape past the dimmer.
The CMY flags and iris take a fraction of a second longer to open than the dimmer blades, however, so
setting CMY and iris blackout to
a blackout.
C U S T O M S E T T I N G S
The custom configuration function allows you to save and recall three sets of fixture settings. The savable
settings are DMX mode, pan/tilt speed, pan/tilt inverse and swap, DMX lamp off and reset, display settings,
shortcuts, studio mode, automatic lamp on, effects feedback, tracking algorithm, and tracking samples.
Readouts
T I M E
→
Under each item is a resettable (
accumulated hours/strikes since fabrication. To reset an increment counter, display it and then press [Up]
until it reads
→
) setting determines whether the gobo and color wheels take the shortest
→
for more linear dimming.
→
) setting controls display brightness. Select
→
).
is
, the lamp remains off until a "lamp on" command is received. When
is set to either
or
) setting allows you to enable (
→
) setting controls the behavior of the reset command. When set to
, the command must be sent for five seconds. The special combination of DMX values listed on
→
) and iris blackout (
, the CMY flags and iris deploy 3 seconds after dimmer blackout. These
(the default setting) allows the fixture to snap open more rapidly after
provides readouts of fixture hours (
. (This may also be done remotely using the MP-2 Uploader.)
) provides two options for dimmer behavior. Select
to
.
) determines whether the display remains on (
), or for 10 minutes after the last key press (
, the automatic lamp strike timing is staggered to prevent all lamps
) or disable (
, the command is disabled to prevent accidental resets. When
→
), lamp hours (
) increment counter and a non-resettable (
Control panel
for automatic
), remains on
).
→
) and DMX Lamp Off
is set to
, the lamp strikes
) the DMX command that
) settings enhance blackout
), and lamp strikes (
) counter for total
to
is
, the
, the
).
13