Martin MAC 700 PROFILE User Manual page 25

4. Position the head top side up so that you have access through the top. Holding the zoom lens by its
base, slide it out it to its limit at the front of the fixture as shown in Figure 16.
Head top side up
5. Flip the head upside-down. Move the focus lens to its forward limit by pulling on its belt as shown in
Figure 17.
Head upside down
6. Flip the head top side up again. To avoid bending the
gobo animation wheel when you remove the
module, move the wheel in towards the center of the
module by inserting a finger and rotating the
positioning belt idler pulley at the top of the module
as shown in Figure 18.
Figure 16: Moving the zoom lens forward
Figure 17: Moving the focus lens forward
Routine maintenance
Figure 18: Retracting the gobo animation
wheel
25