Hans Grohe II Installation Instructions / Warranty page 13

Set the high temperature limit stop (optional)
Loosen the handle screw us-
ing a 3mm Allen wrench.
Grasp the cartridge stop unit
and turn it counter-clockwise
to turn on the handshower.
Turn the stop unit clockwise
to turn the water off.
Remove the handle.
Turn the stem until the output water is the desired maximum
high temperature (usually about 110°F*).
*In Massachusetts, the maximum output temperature cannot exceed 112°F.
Install the stop ring so that the
tooth is against the stop on the
top of the cartridge. Replace
the clip.
English
Remove the clip and the stop
ring from the stem.
Install the handle. Tighten
the screw.
13