Install the pop-up drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
plunger
Unscrew the tailpiece from the tee. Wrap
height adjuster
the threads with two layers of Teflon tape and
replace.
flange
Install the white, flexible sealing gasket on the
flange. Place it in the sink outlet.
From under the sink, install the black mack
sealing gasket
gasket, white friction ring and retainer nut to the
flange. Do not tighten the nut against the bottom
of the sink at this time.
mack gasket
Thread the tee and tailpiece to the flange. The
pivot must face the faucet. If necessary, turn
pull rod
friction ring
the drain assembly.
Tighten the retainer nut.
retainer nut
Place the plunger assembly in the drain.
tee
Install the horizontal rod so that the end goes
through the loop in the bottom of the height
pivot ball nut
adjuster.
Install and hand tighten the pivot ball nut.
tailpiece
Attach the swivel connector to the end of the
horizontal rod
horizontal rod.
Attach the swivel connector to the end of the
pull rod. Position as desired and tighten with a
swivel connector
small, flathead screwdriver.
6