Table of Contents
Advertisement
Install the Pop-up Drain*
plunger
Remove the plunger assembly.
height adjuster
Unscrew the drain outlet flange from the
tee.
flange
Unscrew the tailpiece from the tee. Wrap
the threads with plumbers' thread tape and
replace.
Install the white, flexible sealing gasket to
sealing gasket
the flange. Place it in the sink outlet.
From under the sink, install the black mack
mack gasket
gasket, white friction ring and retainer nut
pull rod
to the flange. Do not tighten the nut against
friction ring
the bottom of the sink at this time.
Thread the tee and tailpiece to the flange.
retainer nut
The pivot must face the faucet. If neces-
sary, turn the drain assembly.
tee
Tighten the retainer nut.
pivot ball nut
Place the plunger assembly in the drain.
Install the horizontal rod so that the end
tailpiece
goes through the loop in the bottom of the
height adjuster.
horizontal rod
Install and hand tighten the pivot ball nut.
swivel connector
Attach the swivel connector to the end of
the horizontal rod.
Attach the swivel connector to the end
of the pull rod. Position as desired and
tighten with a small, flathead screwdriver.
*Drain and pull rod not included with model
31711001.
4
Advertisement
Table of Contents
