Dipswitch Setting; Picture Outline Adjustment - Mitsubishi Electric PH50 series Setup And Installation Manual

1.4.2. Dipswitch setting

Before turning on the main power switch, set the dipswitch correctly according to a system
configuration (see "1.3 Connecting" on page 25). The set ID can be set up to 64 (see "1.5.1.14
EXTENDED ID" on page 43). Be sure to turn off the main power switch if you change the setting
in the middle of the operation. Turning on the main power switch will renew the setting.
OFF ON
1
RC
2
RESERVED
3 MASTER
4
ID5
5
ID4
6
ID3
7
ID2
8
ID1

1.4.3. Picture outline adjustment

Caution
Before turning on, make sure again that the color wheel has been unlocked for
1.2.4.1, on page 8) and, for
1.2.4.2, on page 9).
1.4.3.1. Displaying internal test pattern
Display the internal crosshatch pattern for picture
outline adjustment by pressing [TEST] button
twice in advanced mode.
Adjust to align the outermost lines with screen
edges.
There are another adjustment lines for over-scan
inside the outermost lines. When OVERLAP
setting (chapter 1.5.1.6, on page 40) is ON,
adjust the picture outline so that these lines fit the
screen edges.
PH50, XL50, XL21 series Set-up and Installation Manual
No. Name
1 RC Enabling remote control (ON: enabled, OFF: disabled)
2 RESERVED Normally ON.
3 MASTER MASTER/SLAVE setting (ON: MASTER, OFF: SLAVE)
4 ID5 Designating set ID number (1 to 32) (ON: 1, OFF: 0)
ID No.=1×(ID1)+2×(ID2)+4×(ID3)+8×(ID4)+16×(ID5)
5 ID4
Example:
6 ID3
ID No.=1: ID1=ON, ID2, ID3, ID4 and ID5=OFF
7 ID2
ID No.=32 :ID1, 2, 3, 4 and 5=OFF
8 ID1
X X L L 2 2 1 1 C C h h a a n n g g e e r
30
Function
r , the lamp cushion has been removed (chapter
Adjustment lines for over-scan
Initial
setup
ON
ON
ON
OFF
OFF
OFF
OFF
ON
X X L L 2 2 1 1 (chapter