Table of Contents
Advertisement
1.8.7. Display memory saving
The adjusted values can be saved in a display memory. The number of the memories is 256.
For the saving, an input memory number is required in INPUT MEMORY menu (chapter 1.8.1, on
page 68). If the input memory has not been registered, save the input memory in advance
(chapter 1.7.6, on page 67).
[Procedure]
1.
Press [ESC] button during the display memory menu displaying. In reply to "SAVE THE
CHANGES?" message, press [ENTER] button. You can exit the menu by [ESC] button
without saving.
2.
Designate a memory number to save in by left/right buttons and press [ENTER] button.
3.
The current setting will be saved in the memory if the number is unregistered. When it has
already been registered, the overwrite confirmation message will be displayed.
1.8.8. Display memory calling/deleting
Registered display memory can be called or deleted when needed.
•
Call: Press [MEM LIST] button to select DISPLAY MEMORY. Designate a memory number
to be called by left/right buttons and press [ENTER] button. Or it can be called directly by
3-digit number with number buttons in the remote control. When you call the display memory
1, press 001.
•
Delete: Press [MEM LIST] button to select DISPLAY MEMORY. Designate a memory
number to be deleted by left/right buttons. Select DELETE MEMORY by up/down buttons
and press [ENTER] button in reply to "DELETE OK?" message.
PH50, XL50, XL21 series Set-up and Installation Manual
70
Advertisement
Table of Contents
