Edit Menu - Mitsubishi Electric PH50 series Setup And Installation Manual

4.7.2. Edit menu

4.7.2.1. Read Parameter
Used to update the software data synchronized with selected cube data (chapter 4.3.8, on page
103).
4.7.2.2. Send Parameter
Used to send current memories in the software to selected cubes. You can choose following
options.
•
Only Input Parameter
•
Only Display Parameter
•
Both of Input and Display... : Sending both input and display memory data
•
Only Service Parameter
•
All Parameter
Note: AMP GAIN (on page 54 or 61) values are not sent.
4.7.2.3. Copy Parameter
Used to copy current software memory data in selected panels to a clipboard. AMP GAIN (on
page 54 or 61) values are not included.
4.7.2.4. Paste Parameter
Used to send the memory data copied in "Copy Parameter" menu from the clipboard to selected
cubes.
4.7.2.5. Memory Copy
Used to copy a saved input or display memory data to other memory numbers or other cubes
(chapter 4.4.6, on page 113).
: Sending only input memory data
: Sending only display memory data
: Sending only system memory data
: Sending all memory data described above
117
REV 2.5