INSTALLATION GUIDE > Outputting Plots > Cleaning the Heads
Issue
Model
JV300
7.3 Cleaning the Heads
Outline
There are three kinds of head cleaning. The type to use depends on the results of the test plot
Normal
Soft
Hard
Work procedures
LOCAL
1590mm
Heater///
Ink///
TEST PRINT/
MENU
REMOTE
CLEANING
TEST PRINT
CLEANING
STATION MAINTENANCE >
CLEANING
SOFT
NORMAL
HARD
CLEANING
☑HEAD 1
☑HEAD 2
CLEANING
Please Wait...
00:00
Execute the following settings after performing head cleaning.
• Feed Correction
• Dot position adjustment
© 2014 MIMAKI ENGINEERING CO.,LTD.
Revised
2014.04.11
When there are gaps in lines
When you only want to execute a head wipe (when lines are bent)
When the print quality does not improve even after performing normal cleaning
1. Press the [FUNC2] key in local mode.
2. Select [CLEANING] and press the [] key.
>
>
3. Press [] [] and select the cleaning type.
>
>
>
4. Select the head to be cleaned.
5. Press the [ENTER] key.
6. Execute the test plot again and check the results.
(Operation Manual)
(7.4
(p.11)),
(7.5 (p.14))
F/W ver. 1.00 Remark
• The remaining cleaning time is displayed in the bottom level
of the display.
• When the cleaning finishes, the printer returns to local.
• Repeatedly perform cleaning and test plot until the test plot
result is normal.
Rev.
1.0
(7.2
(p.8)).
1
2
3
4
5
6
7
7.3
R.1.0
P.10