Midas VERONA Operator's Manual page 48

Equalisation
Mono Hi-pass slope
Channels Treble Band
Hi Mid Band
Lo Mid Band
Bass Band
Stereo Treble Band
Channels
Hi Mid Band
Lo Mid Band
Bass Band
Power Supply Information
The number of power supplies shipped as standard with the Verona varies with the frame size as follows:
Channels Internal
24 - 32 1
40 - 56 2
64 2
The internal supplies on the 64 channel Verona should be switched on at approximately the same time so that excessive
load is not applied to any single supply.
The external power supply can be used to add or increase redundancy or to replace the internal supplies. The external
supply has a "daisy chain" facility (as shown below) allowing for a number of power supplies to be used together adding
redundancy to the system in the event of a power supply failing.
Connection 6 Pin Male XLR
Pin 1 0V Analogue
Pin 2 +18V Analogue
Pin 3 -18V Analogue
Pin 4 +12V Gooseneck Light
Pin 5 +48V Phantom
Pin 6 0V Gooseneck Light
Case Chassis
Under NO circumstances should the Venice series power supply be used with the Verona. Only the Midas
V190 Linear External Power Supply is approved for use with Verona consoles.
Servicing and Maintenance
Both the Verona and the Midas V190 linear external power supply both contain potentially lethal voltages and
should only be serviced by authorised Midas service agents. In the event of malfunction, please refer servicing
to qualified personnel. Contact your Midas dealer for more information.
Due to a policy of continual improvement, Midas reserves the right to alter the specification and performance at any time without prior notification.
Verona Specification Verona Specification
12dB/octave
Cut/Boost +/-15dB
Frequency range 2kHz to 20kHz
Cut/Boost +/-15dB
Frequency range 400Hz to 8kHz
Bandwidth 1 Octave
Cut/Boost +/-15dB
Frequency range 100Hz to 2kHz
Bandwidth 1 Octave
Cut/Boost +/-15dB
Frequency range 20Hz to 400Hz
Cut/Boost +/-15dB
Frequency (-3dB) 12kHz
Cut/Boost +/-15dB
Frequency range 600Hz to 8kHz
Bandwidth 1 Octave
Cut/Boost +/-15dB
Frequency range 100Hz to 1.2kHz
Bandwidth 1 Octave
Cut/Boost +/-15dB
Frequency (-3dB) 100Hz
External Redundancy
0 NO
0 YES
1 YES
To console
Front View
PUSH PUSH
DC Output / Link
Power
_
Low + 48V +1 2V 1 8V + 8V 1
Mains
PUSH PUSH
DC Output / Link
Power
_
Low + 48V +1 2V 1 8V + 8V 1
Mains
To subsequent supplies
Operators Manual - Page 46
Rear View
CAUTION
CHECK VOLTAGE SELECTOR
RISK OF ELECTRIC SHOCK BEFORE APPLYING MAINS.
DO NOT OPEN
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE
PUSH
AVIS: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
Pin 1 - 0VA
Pin 2 - + 8V 1 NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO
_ QUALIFIED SERVICE PERSONNEL.
Pin 3 - 1 8V
+ 1
Pin 4 - 2V CAUTION: FOR CONTINUED PROTECTION AGAINST RISK OF FOR CONTINUED PROTECTION AGAINST RISK OF
Pin 5 - + 48V
FIRE REPLACE WITH THE SAME TYPE AND VALUE FUSE INDICATED. FIRE REPLACE WITH THE SAME TYPE AND VALUE FUSE INDICATED. MADE IN KIDDERMINSTER, ENGLAND
Pin 6 - 0VL ATTENTION:
REMPLACER PAR UM FUSIBLE DE MÊME TYPE REMPLACER PAR UM FUSIBLE DE MÊME TYPE
COMME INDIQUÉ.
DC Output / Link
SUPPLY
VOLTAGE
100V/120V/220V/240V
AC~50-60Hz 460W
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND FUSE: 5x20mm
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. T5A L250V C US
CAUTION
CHECK VOLTAGE SELECTOR
RISK OF ELECTRIC SHOCK BEFORE APPLYING MAINS.
DO NOT OPEN
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK,
PUSH DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE
AVIS:
Pin 1 - 0VA RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
Pin 2 - + 8V 1 NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO
_ QUALIFIED SERVICE PERSONNEL.
Pin 3 - 1 8V
Pin 4 - + 1 2V CAUTION:
+ FOR CONTINUED PROTECTION AGAINST RISK OF FOR CONTINUED PROTECTION AGAINST RISK OF
Pin 5 - 48V FIRE REPLACE WITH THE SAME TYPE AND VALUE FUSE INDICATED. FIRE REPLACE WITH THE SAME TYPE AND VALUE FUSE INDICATED. MADE IN KIDDERMINSTER, ENGLAND
Pin 6 - 0VL ATTENTION:
REMPLACER PAR UM FUSIBLE DE MÊME TYPE REMPLACER PAR UM FUSIBLE DE MÊME TYPE
COMME INDIQUÉ.
DC Output / Link
SUPPLY
VOLTAGE
100V/120V/220V/240V
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING CONDITIONS: AC~50-60Hz 460W
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND FUSE: 5x20mm
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. T5A L250V C US