Midas VERONA Operator's Manual page 23

group meters
+21 +21
+18 +18
+15 +15
Rear Panel
+12 +12
+9 +9
+6 +6
+3 +3
0 0
-3 -3
-6 -6
-9 -9
-12 -12
-15 -15
-18 -18
-21 -21
-24 -24 -24
aux aux aux
mtx
mtx
direct mono
Group to Mtx - The group to mtx switch
routes the group signal to the matrix send
pots (discussed later in this section).
aux 1
Mono
sent to the main mono buss via the master
0
sis switch.
+10
MUTE
Pan - The pan control allows the channel
signal to be positioned in a stereo field when
SOLO
routed to the stereo buss. The pan control
group
allows continuous adjustment of the image
aux from hard left, to hard right with a centre
aux
c/o
pre
detent and obeys a constant power law (i.e.
group 1
-3dB at the centre so that the output
group pre
to mtx fade remains at unity).
mono stereo
c
Mute - The mute switch mutes the group
signal at all points after the insert return
l r
pan
(and hence any matrix sends).
master
s i s
MUTE
Solo - The solo switch sends the group
group 1
signal to the AFL stereo and PFL mono
SOLO
busses.
10
Fader
5
adjustment of the group output level from
0 off (-inf) to +10dB.
5
10
15
20
30
40
Each group buss can be connected to external equipment by means of one single
insert insert
G2 G1
balanced male XLR socket (0dBu nominal level).
In addition to this, each group can be inserted into by means of a single
matrix direct
1 in 1
unbalanced quarter-inch TRS jack conventionally wired (0dBu nominal level).
aux out aux out
2 1
XLR Sockets
1 - Screen
group group
2 1
TRS Insert Jacks
T - Signal Send
- When depressed, the signal will be
- The fader allows continuous
Verona Group Outputs Verona Group Outputs
Group Insert
Group Output
2 - Signal Hot 3 - Signal Cold
R - Signal Return S - Screen
Front Panel
group
aux
aux
c/o
pre
group 1
group
pre
to mtx fade
mono stereo
c
l r
pan
master
s i s
MUTE
group 1
SOLO
10
5
0
5
10
15
20
30
40
Operators Manual - Page 21
Group Aux C/O - The group auxiliary
changeover switch is described on the
previous page. When enabled, auxiliary
signals are routed into the group output
controls and hence group should be
mentally changed to 'aux'.
Pre-Fade (Group to Mtx)
depressed, the signal sent to the matrix
send pots is sourced pre-fader and hence
the level will be proportional to the matrix
send pot only. This may be desirable if
using the matrix for
monitoring (e.g. stage side fills).
Stereo - When depressed, the signal will
be sent to the main stereo buss via the pan
and master sis switch.
Master SIS - The master SIS switch will
enable the spacial imaging
whereby the channel pan control operates
in a different way. When panned hard left,
signal is routed to the stereo left output as
normal, similarly when panned hard right,
the signal is routed to the stereo right
output as normal. However, when panned
centre, the signal is routed ONLY to the
mono output creating a LCR (left-centre-
right) system instead of the normal LR
(left-right) system.
- When
recording or
system