Midas HERITAGE 3000 Operator's Manual page 30

The MONO switches connect the post
fader sub group signals to the mono
master bus.
The TALK switches connect the sub
groups to the MONITOR module. When
the TALK INTERNAL or GENERATOR
INTERNAL are active on the MONITOR
module the oscillator, pink noise and talk
mic can be routed to the sub groups.
The MUTE switches mute the sub group
signals at all points after the insert send.
The switches can be controlled from
snapshot automation.
The SPLIT switch changes the sub group
AFL solos from mono to stereo.
The GROUP FADERS give continuous
adjustment of the sub group output levels
from + 10dB to off.
18
to masters
ST ST
MONO MONO
l
c c
r l
pan pan
TALK TALK
INS INS
mute mute
SAFE SAFE
split
SOLO
solo solo
group
HS0011
MIDAS
The ST switches connect the post fader
sub group signals to the stereo master
stereo busses via the pan controls.
The group PAN controls place the sub
groups within the stereo master mix and
have a constant power law i.e. -3dB at
the centre position.
The INS switches connect the group
insert return signals to the sub group
signals.
The mute SAFE removes the channel
mute from snapshot automation.
The SOLO switches send sub group
signals to the PFL mono and AFL stereo
busses. If a SOLO switch is pressed for a
short time it will latch on or off, but, if it
is held on for more than 1 second the
latching is disabled and when the switch
is released the channel solo will turn off.
As a default the solo system is auto
cancelling so each new solo cancels the
last. This function is time dependant
which allows several solos to be active as
long as they are switched on at
approximately the same time, i.e. to solo
both sides of a stereo mix press both solo
switches at the same time. Alternatively
the SOLO ADD MODE switch on the
MONITOR module can be used to defeat
the auto cancelling and allow multiple
channel monitoring. In this mode input
channel solos have priority over the sub
group solos and will temporarily override
them. When the input solos are cancelled
the mix group solos will be active again.
Sub group solos can also be temporarily
overridden by activating the
corresponding direct input solos.