Table of Contents
Advertisement
Midi In Assignment:
Setting The Console to Respond to
The console settings can be accessed via the "AUTO" submenu after pressing the "System" button. This
submenu option is only available when in "SYS" Lock-Mode.
After selecting "AUTO", there are two further sub-menus:
1. ENAB -(ENABle), this is the master switch for this function and can be set to "YES" or "NO". Toggling this
switch will not delete the other setup parameters for this function.
2. SETP - (SETuP), this is where we set the actual midi parameters that are used for this function. These
parameters define the midi command that the console will respond to, and decode the required act/scene
number. The two parameters that can be set are as follows:
a. The midi command, this can be either of the following midi commands:
N ON - (Note ON)
NOFF - (Note OFF)
SNGP - (Song Pointer)
PRCH - (Program Change)
b. The
MIDI
channel, this covers the full 16 channels possible, the display shows CH 01 - CH 16.
Notes:
1. To respond to an external midi request to change the act/scene number, the following conditions must be true:
a. The "AUTO - ENAB" menu setting must be set to "YES".
b. The console must not be in "TOTL" (TOTaL) Lock-Mode.
C. The console use must not be performing any menu operations.
Setting Up a Midi Device:
To cause the console to automatically change its act/scene, a MIDI command can be sent using the pre -
programmed command & channel (as set on the console). The actual act/scene number is encoded into the
MIDI command data that is sent.
The required MIDI command data can be constructed by setting the midi command parameters as follows:
Note ON/OFF : These MIDI commands have two parameters, as follows:
1. NOTE, this parameter is equivalent to the required "ACT" number.
2. Velocity, this parameter is equivalent to the required "SCENE" number.
Example: To program a change to ACT 20, SCENE 44, - Set the note to G#-1,
Song Pointer - The command is a numerical value and is equivalent to the combined
"ACT" & "SCENE" number.
Example: To programme a change to ACT 45, SCENE 02, - set the value to 4502
MIDI
Each note has a numerical equivalent (see table below)
set velocity to 44.
Changes:
45
Hide quick links:
Advertisement
Table of Contents
