Midas HERITAGE 3000 Operator's Manual page 43

The VCA switches assign the matrix
outputs to VCA control from the
MASTER module fader.
The INS switches connect the matrix
insert return signals to the matrix mixes.
The mute SAFE switches remove the
matrix mutes from snapshot automation.
The SPLIT switch changes the matrix
AFL solos from mono to stereo.
The MATRIX faders give continuous
adjustment of the matrix output levels
from + 10dB to off.
masters
control
VCA VCA
TALK TALK
INS INS
mute mute
SAFE SAFE
split
SOLO
solo solo
10
5
0
5
10
20
30
40
dB
matrix
MIDAS HS0041
The TALK switches connect the matrix
mixes to the MONITOR module. When
the TALK INTERNAL or GENERATOR
INTERNAL are active on the MONITOR
module the oscillator, pink noise and talk
mic can be routed into the matrix mixes.
The matrix MUTE switches mute the
matrix signals at all points after the insert
send. The switches can be controlled from
snapshot automation.
The SOLO switches send matrix signals
to the PFL mono and AFL stereo busses.
If a SOLO switch is pressed for a short
time it will latch on or off, but, if it is held
on for more than 1 second the latching is
disabled and when the switch is released
the channel solo will turn off. As a default
the solo system is auto cancelling so each
new solo cancels the last. This function is
time dependant which allows several
solos to be active as long as they are
switched on at approximately the same
time, i.e. to solo both sides of a stereo
mix press both solo switches at the same
time. Alternatively the SOLO ADD
MODE switch on the MONITOR
module can be used to defeat the auto
cancelling and allow multiple channel
monitoring. In this mode input channel
solos have priority over the matrix solos
and will temporarily override them.
When the input solos are cancelled the
matrix solos will be active again.
31