Table of Contents
Advertisement
To stop copying
Press {STOP}.
To select the resolution
1. Press {RESOLUTION}.
2. Press {V} or {^} repeatedly to select the
desired resolution.
– "TEXT/PHOTO": For documents
containing both text and photographs.
– "TEXT": For documents containing only
text.
– "PHOTO": For documents containing
photographs, shaded drawings, etc.
Note:
L You can change the default resolution in
feature #461 (page 64).
To select the contrast
You can adjust this setting depending on the
darkness or lightness of the document. 5 levels
(light to dark) are available.
1. Press {CONTRAST}.
2. Press {V} or {^} repeatedly to select the
desired contrast.
L To make it lighter, press {V}.
L To make it darker, press {^}.
Note:
L You can save the previous contrast setting in
feature #462 (page 59).
5.2.2 Using the scanner glass
L Confirm that there are no documents in
the auto document feeder.
{COPY}
1
If the {COPY} light is OFF, turn it ON by
pressing {COPY}.
2
Set the original.
1. Open the document cover (1).
2. Place the document FACE DOWN on the
scanner glass (2), aligning the top left
corner of the document to the l mark on
the unit.
3. Close the document cover.
L If the original is a thick book, do not
close the document cover.
3
If necessary, change the following settings
according to the type of document.
L To select the resolution, see page 45.
L To select the contrast, see page 45.
4
If necessary, enter the number of copies (up
to 99).
5
Press {START}.
L The unit will start copying.
6
After you finish copying, press {STOP} to
reset the settings you set in step 3 and 4.
Note:
L The effective scanning area changes
according to the setting of the paper size
(feature #380 on page 59). If you select
"LEGAL" for the paper size, the effective
scanning area will be maximized (page 30).
To stop copying
Press {STOP}.
5. Copy
1
2
{STOP}
{START}
45
Advertisement
Table of Contents
