The Radio - Panasonic SC-VK450 Operating Instructions Manual

The radio

Manual tuning
1
Select "FM" or "AM".
The unit comes on.
If noise is excessive in FM
Press [PLAY MODE] to display "MONO".
Monaural sound is selected and noise reduces when
reception is weak.
Press [PLAY MODE] again to cancel the mode.
"MONO" is also canceled if the frequency is changed.
Memory preset (remote control only)
There are two methods of pre-setting stations.
Automatic presetting : All the stations the tuner can receive are preset.
Manual presetting
Up to 15 stations each can be set in the FM and AM bands.
Preparation
Press [TUNER/MUSIC P.] to select "FM" or "AM".
Automatic presetting
ENTER
Press and
hold until the
frequency
changes.
Selecting a preset station
1
Select "FM" or "AM".
22
22
2
Press and hold [
starts scrolling to start automatic tuning. Tuning
stops when a station is found.
: You can select the stations to preset and the order they are preset in.
Perform the following once each for
FM and AM.
Preparation
Tune to the frequency where pre-
setting is to begin.
• The tuner presets all the stations
it can receive into the channels in
ascending order. The last station to
be set is then played.
2
Select the frequency.
] or [ ] until the frequency
AM allocation setting
This system can also receive AM broadcasts allocated in
10 kHz steps in addition to the 9 kHz steps.
To change the step from 9 kHz to 10 kHz
1
Select "FM".
2
Press and hold [TUNER, BAND].
After a few seconds the display changes to a flashing
display of the current minimum frequency.
3
Continue to hold down [TUNER, BAND].
• When the minimum frequency changes, release
the button. To return to the original step, repeat the
above steps.
• After changing the setting, previously preset
frequency will be cleared.
Manual presetting
Pre-set the stations one at a time.
Tune to the
station
( see
above).
The station occupying a channel is erased if another
station is preset in that channel.
or
"TUNED" is displayed when a
radio station is tuned.
"ST" is displayed when a
stereo FM broadcast is being
received.
(main unit only)
ENTER
While "PGM" is flashing
on the display
Select the channel.
• To select a 2-digit number
Example: 12: [ 10] [1] [2].