MAINTENANCE WORK ON CHASSIS AND ENGINE
Removing the oil filter
x
9.107
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Installing the oil filter
x
9.108
–
Place a suitable container under the engine.
–
Remove engine oil plug screen
–
Completely drain the engine oil.
–
Thoroughly clean the plug and engine oil screen.
–
Clean the sealing surface on the engine.
–
Mount and tighten the engine oil screen drain plug
Guideline
Plug, engine oil screen
200112-10
–
Place a suitable container under the engine.
–
Remove screws
200113-10
–
Pull the oil filter insert
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean parts and sealing surface.
200114-10
–
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill the oil filter
–
Lubricate the O/ring
200114-11
.
M17x1.5
. Remove oil filter cover
out of the oil filter casing.
with engine oil and place it in the oil filter container.
of the oil filter cover.
.
20 Nm
(14.8 lbf ft)
with the O-ring.
81