Site Survey - NetComm INFRASTRUCTURE SERIES User Manual

4.2.8 Site Survey

If Universal Repeater function is enabled, the system can scan and display all surrounding available access points
(APs). The administrator can then select an AP to be connected to extend its wireless service coverage on this
page.
•
SSID: The SSID (Service Set ID) of the AP found in the system's coverage area.
•
MAC Address: The MAC address of the respective AP.
•
Channel: The channel number currently used by the respective AP or repeater.
•
Rate: The transmitting rate of the respective AP.
•
Signal: The signal strength of the respective AP.
•
Security: The encryption type used by the respective AP
•
Setup/ Connect:
Connect: Click Connect to associate with the respective AP directly; no further configuration is required.
Setup: Click Setup to configure security settings for associating with the respective AP.
WEP: Click Setup to configure the WEP setting for associating with the target AP.
o
The following configuration box will then appear at the bottom of the screen.
configured here must be the same as
NP727 User's Manual V1.00
the AP
target .
Security settings