NetComm NP726 Product Data Sheet

How to configure the IAC4500 Internet Access Controller for Billing
by Volume Application with NCT480 IP DSLAM using port location
mapping
Introduction
The following paper provides instructions on how to configure NetComm's IAC4500
Internet Access Controller with NetComm NCT480 IP DSLAM for 'billing by volume'
application. It specifically focuses on the IAC4500's new feature 'billing by volume'
under deployment scenarios A: Port Location Mapping for 802.1Q VLAN Tagging.
This document is being created at a time when the following versions of firmware were
in production:
• IAC4500: Firmware V1.02.05
• NCT480: Firmware R2.32
(Note: IAC4500 with firmware V1.02.05 or later supports billing by volume)
The test PCs that used in this white paper were running WinXP with Internet browser
IE7.0. (The web interface of the devices under test in this white paper are best
viewed with Microsoft Internet Explorer 6.0 and above at 800 x 600 resolution)
It is recommended that the readers of this document has read and understood the
IAC4500 & NCT480 user manual.
How to configure NetComm IAC4500 for billing by volume application with NCT480 IP DSLAM using
port location mapping
Nov2008
1
CL Page