Advertisement
Available languages
Available languages
installation instructions
Electrical
Shock Hazard
Disconnect
electrical
power at the fuse box or circuit
breaker box before installing
dishwasher.
Failure to do so can result
in death or electrical
shock.
1. Disconnect
power.
2. Turn off water supply.
Prepare
cabinet
opening
using
existing
utility
hookups
Follow the steps in this section
if you are installing
the
dishwasher
in an existing
cabinet opening
with utility
hookups.
If you are installing
the dishwasher
in a cabinet opening
that does not have hookups,
follow
the steps under
"Prepare
cabinet opening
where there are no existing
utility
hookups"
section.
1. Check that the water
II
line reaches to the
front left of opening
where the water
water
connection
will be
line
made.
I
/
_
2. Check that the direct
I.
,_
wire reaches to the
--
front right of opening
where the electrical
connection
will be made.
If the water
line and the direct wire reach far enough into
the opening,
proceed to the next section
"Install
the drain
hose."
If they do not reach far enough,
follow
the steps
under "Prepare
cabinet opening
where there are no
existing
utility
hookups."
Install
the drain
hose
IMPORTANT: Always
use a new drain hose even when
installing
a new replacement
dishwasher.
1. Drill a 11/2 .' (3.8 cm) diameter
hole in cabinet wall or
floor on the side of the opening
closest to the sink.
L
2. Connect drain hose to waste tee or waste disposer
using one of the following
methods:
, Option
1, Waste disposer
- with Air gap
, Option
2, No waste disposer
- with Air gap
, Option
3, Waste disposer
- no Air gap*
, Option
4, No waste disposer-
no Air gap*
*An Air gapis recommended.
Helpful
Tip: To reduce
the vibration
of the
hose,
keep
the
hose away
from
the floor
and the edge
of the
hole
where
it passes
through
the cabinet.
Option
1, Waste disposer
- with Air gap:
1. Remove the disposer
knockout
plug. Cut end of drain
hose if needed (do not cut ribbed section).
2. Attach drain hose to Air gap with large spring-type
clamp. If the drain hose was cut, use a 11/2 '' to 2"
(3.8 to 5 cm) screw-type
clamp*.
3. Use a rubber
hose connector*
with spring or screw-
type clamps*
to connect
Air gap to disposer
inlet.
This connection
must be before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher
will be installed.
drain hose-
cut here if needed
rubber
hose
connector
spring-type
clamp
hose
drain trap
4.
Insert drain hose
through
hole cut in
cabinet to the front
center of opening
where
drain connection
will be
made.
drain hose
*Parts available
from local plumbing
supply
stores
Advertisement
