Kenmore 66513206K902 Installation Instructions Manual page 11

Install custom panel
Model 665.1320
NOTE: The handle for the custom panel is not included.
IMPORTANT: If the handle is attached from the back of
the custom panel, the screw holes should be countersunk
for the screws heads to be flush with the panel. If the
handle is attached to the front of the custom panel, the
screw lengths cannot exceed the panel thickness.
NOTE: A customer-supplied full front panel must weigh
no more than 16 Ibs (7.3 kg) and must be made to
specific dimensions. It is recommended that a
cabinetmaker cut the custom panel because of the
precise dimensions needed.
NOTE: All mounting hardware supplied is for a 3/4"
(19.1 mm) thick wood panel. If a thinner wood panel, or
materials other than wood are used, it is the consumer's
responsibility to obtain the proper length screws and
adjust the pilot holes accordingly.
IMPORTANT: Use a moisture-resistant sealer on both
sides and all edges of the panel to avoid damage from
humidity.
231/2" "_'_'_,30sA ,, (7 6.7 c m)
7 cm/
*This dimension is for 4" (10.2 cm) toe kick as measured
on cabinetry. If the installation needs a higher toe kick,
adjust the height of the wood panel accordingly. Not
recommended for toe kicks greater than 6" (15.2 cm). ,J
With a TORX ®screwdriver, remove three screws from both
sides, as shown; hold the outer panel up while removing
the screws. Save screws for reinstallation.
ii
.... i i
3 screws
per side
outer
Gently set outer panel aside. Lay the customer-supplied
custom panel face down on a covered, non-scratching
surface.
929/32 't
(25.2 cm)
p edge
Measure 92%2"(25.2 cm) from top edge and mark a line on
the back of customer-supplied custom panel. Position the
outer panel on the back of the customer-supplied custom
panel as shown, so that the top holes in the outer panel are
on the line, and both panels are centered side to side. The
top edge of the panel has folded corners as shown in Step 4.
Mark pilot
holes
Top
edge
NOTE: Pilot hole depth is given for a 3/4"(15 mm) thick
panel. Thinner panels require shallower pilot holes.
Mark all 4 hole locations; remove outer panel. Drill 3/32" p ilot
holes 1/2"(13 mm) deep in customer-supplied custom panel.
Place the outer panel on the back of the customer-supplied
custom panel; align holes. Attach outer panel to back of
customer-supplied custom panel with the four
#10-16 x 3/8"hex-head screws supplied in the literature
package.
NOTE: Handle is not included with this model.
Attach the handle. The handle should be centered on the
front of the customer-supplied custom panel in the area
shown.
IMPORTANT: Screw heads must be flush with back of
customer-supplied custom panel.
11