Kenmore 66513206K902 Installation Instructions Manual page 12

?
R edges
3 screws
each side Customer-supplied
panel
J
Attach the panel assembly to the door by reinstalling the 3
screws on each side; do not tighten completely. This
reinstallation of the three screws will hold the panel
assembly in place on the door frame.
top
edges
Drill through
theseholes
Customer-supplied
panel
Align the top edge of the customer-supplied custom
panel with the top of the console.
Drill two 3/32"pilot holes 1/2"(13 mm) deep, into the
customer-supplied custom panel, through the holes in the
top corners on the inner panel, as shown.
NOTE: Pilot hole depths are given for a 3/4" (15 mm) thick
panel. Thinner panels require shallower pilot holes.
top
edges
:)rill through
these holes
Customer-supplied
panel
\13A'!Screw
Install the two #8-18 x 13/8"screws from
the literature package in the top corners of the inner
panel. Tighten the six side screws reinstalled in Step 6.
12
Choose attachment option
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
The dishwasher must be
secured to the cabinet. There
are two brackets that can be /
attached to the countertop if it
/J
is wood, laminate or another "_//
similar surface. If your _ _/
countertop is marble, granite
or other hard surface, the
brackets may be moved to the
sides of the dishwasher.
NOTE: Do not attach the
dishwasher. This will be done
Using two or more people, stand the dishwasher up.
Option 1, Countertop attachment
brackets__
later.
Option 2,
front vent
model shown
Dishwasher side attachment
(for marble, granite or other hard surface
countertop)
1. To remove the brackets from the top, flatten tab at back
of brackets with pliers, and pull the brackets out of the
slots.
2.
J
)S
Break off the end of the bracket along the scored line.
score
line
3. With another person holding the dishwasher to avoid it
from tipping, open dishwasher door, and place towel
over pump assembly and spray arm of dishwasher.
This will stop screws from falling into pump area when
securing dishwasher to cabinet.
4. Push the plastic buttons out of the side of the tub.
NOTE: Save the buttons to cover the holes after
dishwasher is installed.
5.
Push bracket into slot on the side of dishwasher, and
bend tab in toward the side of the dishwasher so that it
keeps the bracket in place.
NOTE: Do not attach the dishwasher. This will be done
later.
I
2/