Advertisement
Available languages
Available languages
Drain Requirements
Use the new drain hose supplied
with your dishwasher.
If this is not long enough,
use a new drain hose with a
maximum
length of 12 ft (3.7 m) that meets all current
AHAM/IAPMO
test standards,
is resistant
to heat and
detergent,
and fits the 1" (2.5 cm) drain connector
of
the dishwasher.
Connect drain hose to waste tee or disposer
inlet
above drain trap in house plumbing
and 20" (50.8 cm)
minimum
above the floor. It is recommended
that the
drain hose either be looped up and securely fastened
to the underside
of the counter, or be connected
to an
Air gap.
, Use an Air gap if the drain hose is connected
to house
plumbing
lower than 20" (50.8 cm) above subfloor
or
floor.
Use 1/2"minimum
I.D. drain line fittings.
Water
Supply
Requirements
A hot water
line with 20-120 psi (138-862 kPa) water
pressure.
120°F (49°C) water at dishwasher.
3/8"O.D. copper tubing
with compression
fitting
or
flexible
stainless
steel braided fill line (W' minimum
plastic tubing
is not recommended).
A 90 ° elbow with 3/8" N.RT. external
pipe threads on
one end.
Do not solder within
6" (15.2 cm) from water inlet
valve.
Electrical
Requirements
Contact
a qualified
electrician.
Assure that the electrical
installation
is adequate
and in
conformance
with all national and local codes and
ordinances.
You must have:
120-volt, 60 Hz, AC-only, 15- or 20-amp, fused electrical
supply.
Copper wire only.
We recommend:
A time-delay
fuse or circuit
breaker.
A separate circuit.
If direct wiring
dishwasher:
Use flexible,
armored
or nonmetallic
sheathed,
copper
wire with grounding
wire that meets the wiring
requirements
for your home and local codes and
ordinances.
Use strain
relief method
provided
with house wiring
junction
box or install a UL Listed/CSA
Approved
clamp
connector
to the house wiring junction
box. If using
conduit,
use a UL Listed/CSA
Approved
strain relief.
If connecting dishwasher
with
a power supply cord:
. Use Power Supply
Cord Kit (Part Number
4317824)
marked for use with dishwashers.
Kit contents
include:
- Volex, Inc., UL Listed 16 gauge 3 wire power supply
cord with 3 prong grounding
plug.
- Neer C-500 7/8"strain
relief.
- 3 wire connectors.
- Part Number
302797 grommet
Follow the kit instructions
for installing
the power
supply cord.
. Power supply cord must plug into a mating three prong,
grounded
outlet, located in the cabinet next to the
dishwasher
opening.
Outlet must meet all local codes and
ordinances.
Advertisement
