LifeSpan PRO series Owner's Manual page 8

STEP 1: Handlebar Support Post Assembly
18
17
A. Stand up the handlebar post (4) and attach the 4 dome head screws on the bottom of the
handlebar posts (17). You may need to move the post forward and back slightly to properly
align the holes. Make sure these 4 screws a securely tightened.
B. Lift up the handlebars and remove screw (18) and washer (20) from the bottom of the left and
right sides of the handlebars.
C. Replace screws (18) with washers (20) underneath the handlebars securely to lock the handlebars
in place.
D. Assemble the "U" shaped safety bar by first removing screws (18) and washers (20) from the
bottom of the hand rail. Then place the hand rail in position and secure screws (18) and washers
(20) from underneath the console support post.
Notes:
1. Please hold the handlebars carefully in place during this step to prevent them from falling.
2. When raising the handlebars, be careful not to pinch the wiring harness.
STEP 2: Base Cover Assembly
FIG-5
4
13
12
22
21
A. On each side, remove the 2 screws (22) that hold the front and back of the base covers together.
B. Fasten the outside portion of the base cover on the right and left sides of the treadmill using
the Phillips head screws (21) that are pre-installed at the factory onto the treadmill frame.
C. Attach the back of the covers using Phillips head screws (22)
5
8
20
17
6
18
20
18
4
14
22
21
15
10
STEP 3: Handlebar and Console Assembly
FIG-6
9
20
10
18
20
22
22
A. Rotate the console to the proper position. Tighten the dome head Allen screws (22) on the
back of the console support tube to lock the console in place.
B. Mount the right and left storage trays.
FIG-7
11
22
5
22 6
4
11
FIG-8
17
20
19
7
20 19
17