Pellergy PB-1525 Installation & Operation Manual page 36

PB-1525 Wood Pellet Burner System: Installation and Operation Manual
Rev 1.0, OCTOBER 2011
"Parm" or Parameters and "Test" for the test menu. Figure 3.9 below
depicts the controller in the Technician Mode, disabled.
Figure 3.9: PB-1525 Burner Controller in the Idle State, Technician Mode
The above menu is the starting place for setting up the system. To enter
this state on the controller perform the following steps:
1.) Power the unit in Technician Mode
2.) As soon as the controller enters the Purging State, press and hold
the Disable button.
3.) Once the unit has been Disabled, press the End button.
The display will now appear as it does in Figure 3.9 above and the initial
system set points may be entered.
Pressing the Parameters or Test button will allow the Certified Installer to
scroll through the settings and tests made available within the controller.
Pressing no button for 5-6 seconds will cause the display to revert back to
that shown in Figure 3.9 above.
Operational Parameters
Idle
i 0 65°F
Starts: 129
Parm Test
with the unit Disabled
0
_
Ena Feed
Page 36 of 67