Chapter Three: System Setup & Operational Overview; Controller User Interface Description; Stack Gas Temperature - Pellergy PB-1525 Installation & Operation Manual

PB-1525 Wood Pellet Burner System: Installation and Operation Manual
Rev 1.0, OCTOBER 2011
Chapter THREE: System Setup & Operational Overview

Controller User Interface Description

All system setup features are accomplished through the user interface on
the controller. Illustrated in Figure 3.0 below, the user interface consists of
a backlit alpha numerical display, four buttons and two LEDs. The
interface is direct mounted on the back of the burner and accessible at
all times.
Red LED
Green LED
Figure 3.0: PB-1525 Burner Controller Interface
The display indicates system status and serves as an information panel for
the Certified Installer and Operator. It contains four rows of alphanumeric
characters and displays the following information:
 System State (Various)
 Thermostat Status (On-Off)
 Stack Gas Temperature (Degrees F)
 Flame Sensor Value (0-255)
 Auger Feed Motor Status (On-Off)
 Hours (Run Time Meter in Hours)
 Resets (Number of System Resets)
 Starts (Number of Start/Stop Cycles)
 Ignitor Status (On-Off)
 Combustion Blower Status (High, Med, Low Speed or Off)
 Alarm Display (Various)
 Button Functions (Various)
The following sections of this manual will discuss the display during the
various states of the controller.
Alphanumeric Display
Buttons (1-4)
Page 26 of 67