Electric Installation - Pellergy PB-1525 Installation & Operation Manual

PB-1525 Wood Pellet Burner System: Installation and Operation Manual
Rev 1.0, OCTOBER 2011

Electric installation

General
All electrical connections to the PB-1525 wood pellet burner system are
made in the supplied connection panel. The panel is factory wired with
two quick-connect cable sets that connect directly to the PB-1525 burner
head. All field connections are made to the supplied terminal blocks in
the connection panel. A terminal connection listing is provided below as
well as on the door of the terminal panel enclosure. Figure 2.5 below
shows a detail of the enclosure. Four (4) knock outs are supplied on both
sides of the enclosure as well as three (3) on the top for in-field installation
of the proper connector for the wire being used. The two (2) outermost
connections on the bottom of the panel are used by Pellergy for the
factory wired and installed cable/connectors sets. The center knock out
may be used for the installation of cables.
6.00
TOP VIEW
8.00
SIDE VIEW FRONT VIEW SIDE VIEW
4.00
BOTTOM VIEW
Figure 2.5: Pellergy PB-1525 Terminal Panel Enclosure Exterior Detail
Page 19 of 67