System Setup - Pellergy PB-1525 Installation & Operation Manual

PB-1525 Wood Pellet Burner System: Installation and Operation Manual
Rev 1.0, OCTOBER 2011
Grn
Grn
Grn
Grn
Grn

System Setup

The PB-1525 is intended to be set up in the field by a Pellergy Factory
Trained Certified Installer. There are no parameters that can be set up by
the homeowner or system operator. In order to set the system
parameters, the Certified Installer must place the controller in "Technician
Mode" to make adjustments. These adjustments control various
operational aspects of the system and ensure both reliable and safe
system operation.
WARNING! System operational parameters are to be set by the Pellergy
trained Certified Installer only. "Technician Mode" on the
controller is intended for the exclusive use of Pellergy trained
Certified Installers. Modification of the system settings by
anyone other than a Pellergy trained Certified Installer may
cause an unsafe operational conditions that can result in injury,
bodily harm, equipment damage and even death.
Certified Installer Settings
There are two menu headings available on the display within Technician
Mode that allows the Certified Installer to adjust for proper firing of the PB-
1525 system and test certain operational settings on the unit. These are
Idle
Red
Operating
Red
Burner Disabled, Operating
Red
Burner Disabled, Not Operating
Red
ALARM
Red
LED Off
LED On
LED Flashing
LED Solid
Page 35 of 67