Quick Set; Part Set - Cooper Security i-on16 User Manual

Everyday Operation

Quick Set

Quick Setting does not require the use of an access code or tag.
(The Installer must enable this facility for you.)
Make sure the system is idle.
1. Press A.
The keypad gives the exit
warning tone.
2. Leave by the exit door and
make sure it is closed
properly.
At the end of the exit time the
display shows the message
"System Set" for a few
seconds.
While the system is set the
display shows the standby
screen.
Note:
If you decide you want to stop setting then press

Part Set

When programming your system, the installer can mark some of
the zones "Part Set". If, when setting the system, you press B
instead of A then the control unit sets the zones selected by the
installer, and none of the others. This feature is designed so that
you can protect, for example, the perimeter of your house while
you remain inside it, or the downstairs rooms while you are
asleep upstairs.
Page 8
Setting:Full Set
10 to set
System set
.