Cooper Security i-on16 User Manual page 9

At the end of the exit time the
exit warning tone stops and
you should hear a double
"beep" confirmation tone to let
you know that the system is
set.
The display shows the
message "System Set" for a
few seconds, followed by the
standby screen. The LED
marked "A" glows to show that
the system is full set.
Notes:
a) If you decide you want to stop setting then press
b) Your system may be programmed to set silently. If so,
there will be no exit warning tone as the system sets.
c) If your system is full set you cannot go directly to part
set. You must unset the system first.
d) If your system is part set, then you cannot go directly to
full set. You must unset the system first.
Everyday Operation
System Set
.
Page 7