Advertisement
Welcome!
Congratulations on your purchase of the M5-1002, Optical DVI+Audio extender.
This manual contains information that will assist you in installing and operating
the product.
Product Description
The M5-1002 module offers up to 2 Km extension of DVI digital graphic data,
audio and RS232C serial data over fiber, directly connected between computers
and displays or audio or RS232C devices. Two modules, located one in the PC
side and the other in the display or devices side are connected to each of them
by a 1.0 m DVI copper cable or audio cable or RS232C cables. Between the two
modules, the SC terminated optical fiber enables to transmit not only TMDS
graphic data and audio signal over it but also the Digital Display Channel
(DDC2B) interface and Hot-plug function are performed over the same optical
fiber.
Shipping Group of M5-1002 Optical DVI + Audio extender
Tx and Rx boxes: One Uplink module & One Downlink module.
AC/DC power adapter: Two +12V/3A units (including AC cord).
User's Manual
Option: Duplex SC fiber (Single mode glass fiber).
Figure 1 – Overall Optical DVI+Audio Extender system
1-1 Welcome, Product Description
System Requirements for Setup
Hardware requirements
You have a graphic controller card with a DVI port in your
Windows/Mac (Mac is option), or SUN system. It should support
the maximum graphic resolution feature of the display to be
connected.
In case of using a computer, no special memory size, CPU
speed and chipsets are required.
Proper initial trial of the entire platform with its application using
a short length copper cable is recommended prior to install with
the optical link.
Software requirements
No special needs, if the DVI graphic controller and display
peripheral are operational with the platform's OS and
application.
AC/DC Power Adapter Technical Advisory
The power of M5-1002 is designed to supply to each module of
Uplink and Downlink modules by plugging to each of the power
plugs.
1-2 System Requirements for Setup
Advertisement
