Slide Range Into Opening - GE P2S975 Installation Instructions Manual

Installation Instructions
[]
[]
SLIDE RANGE INTO OPENING
Position the range in front of the cabinet
opening.
[] Make sure the supports which overhang
the countertop dear the countertop.
If necessary, raise the unit by lowering
the leveling legs.
[] Push while lifting the range into the
opening, until the range is within 2"
of engaging the anti-tip bracket.
[] Remove the protective trim from the side
(if provided).
[] Using the adjustable pliers or wrench,
carefully screw in the back leveling leg
until the overhang comes to rest on the
countertop.
[] Carefully screw in the front two leveling
legs (similar to Step E) until the overhang
touches the countertop.
[] Carefully push the range into the opening
until the countertop fully engages the
control pane[. The back maintop overhang
should cover the cutout opening.
Counte_op
Make sure the edge of
the countertop fits flush
against the end of the
front control panel
SLIDE RANGE INTO OPENING
(cont.)
[] Plug the range cord into the receptacle.
Locate the cord in the back of the range
in a manner that it will not touch or be
moved by the drawer.
Position range cord
so that there is no
interference with .
F] storage drawer _..
//
\
. \
\
tl/
j
\
/
\
\
/I/
/////
I_1 FINAL CHECK OF ANTI-TIP
BRACKET
When installation is complete and the range is
in place, check to be sure that the rear leveling
leg is fully inserted into the slot of the Anti-Tip
Bracket.
13