Appendix C: Colormerge Installation; Colormerge Setup; Adding A Colormerge Module To A Source Four Fixture; Installing Colormerge - High End Systems Dichroic Theatre Series User Manual

Appendix C:
ColorMerge Installation

ColorMerge Setup

The ColorMerge module ships with the following items:
• ColorMerge product
• Declaration of Conformity

Adding a ColorMerge Module to a Source Four Fixture

Warning: INTENSE HEAT. AVOID CONTACT BY PERSONS AND MATERIALS.
Warning: CHALEUR INTENSE. ÉVITER TOUT CONTACT ET TENIR TOUTE
MATIÈRE À L 'ÉCART.
Perform this procedure before you connect the fixture to power. Refer to Figure C-1 as you
complete these steps. To install a ColorMerge moduld in a Source Four ellipsoidal fixture:
1. Remove the front
barrel assembly of
the Source Four
ellipsoidal fixture
by loosening the
thumbscrew and
the Philips set
screw located
above and
beneath the lens
barrel. You must
rotate the barrel
assembly until it
releases from the
mounting tabs
located in the rear
housing assembly.
2. Insert the ColorMerge module into the Source Four rear housing assembly by
aligning the mounting tabs into the rear-locking ring of the ColorMerge module. You
must rotate the ColorMerge module until the Source Four mounting tabs are
captured in the ColorMerge locking ring channels.
Dichroic Theatre ™ User Manual
Safety cable mount
Retainer bolt
Barrel
Figure C-1 Installing ColorMerge
Reflector housing
Y oke
Y oke locking knob
Barrel rotation knob
ColorMerge Installation
C
C-1