(Dmx) Menu; Set The Dmx Start Channel (Addr); Set The Addressing Mode (Mode) - High End Systems Dichroic Theatre Series User Manual

Level 1 Level 2 Level 3 Level 4 Options
DISC
INIT
TEST
FULL
SELF
OPEN

(DMX) Menu

Use this Menu option to set the Start channel for the ColorPower supply as well as
colormixing fixtures linked to it. For more information on setting a DMX start
channel (see "DMX Addressing" on page 2-4).

Set the DMX Start Channel (ADDR)

1. To enter the Menu system, press and hold the <Menu> button until
appears on the LED display.
2. Using the <Up> and <Down> arrow buttons scroll to the desired start channel
(1-512)
value

Set the Addressing Mode (MODE)

The ColorPower supply has three modes for DMX. Manual Addressing and Auto
Addressing are described here. Discovery (DISC) addressing is recomended for
troubleshooting situations only. You can find more information about the DISC mode
in "When to use Discovery addressing" on page 4-6.
Manual Addressing. allows the user to assign DMX addresses to fixtures attached to
the link. Addresses may be assigned to any valid DMX address following the
ColorPower supply Start channel. As the addresses are selected, both fixture type
and address are stored in an on board EEPROM. Thereafter, ColorPower acquires its
addressing information from this EEPROM. If fixtures are added to the link after
selecting MANU, they will be assigned an invalid address. If fixtures are removed
from the link, they will be ignored. In either event, removal or addition of fixtures
will not change addressing, and thus will not change your show. The manual address
mode allows multiple fixtures to share the same DMX address when you require
more than one fixture to respond identically to the controller.
Use the following steps to manually address fixtures on the ColorPower link:
1. Press and hold the <Menu> button until
2. Press the <Enter> button to enter the DMX menu system. The first option will
AddR
be .
ModE
3. Navigate to the
4. Press the <Enter> button to enter the addressing mode sub-menu system. The
first option will be the
MANU
5. Navigate to the
Dichroic Theatre™ User Manual
Discovers all color mixing units attached to this
ColorPower supply. Displays DONE when complete
Displays
pause the display alternates between
=100) and
fixtures responding.
the <Enter> button to select.
menu by pressing the UP button.
AUTO
addressing mode.
menu by pressing the UP button.
Description
INIT
indicating that it is initializing. After a
OPEN
(DMX = 0) with all the linked
dMX
appears on the LED display
FU LL
(DMX
3
dMX
Operation 3-3